L3 configuration on Ufispace equipment

Static and Dynamic Routing Protocols, OSPF and BGP We’re going to present Layer 3 (L3) configuration on Ufispace equipment, both static and dynamic, using protocols such as OSPF (Open Shortest Path First) and BGP (Border Gateway Protocol). Below is a guide to configuring these features. To start the configuration, you need to access the Ufispace device via the command line interface (CLI). We will demonstrate access via ssh, but it can also be done via serial connection and telnet. Configuration directly on the interface: Example vlan Sub-Interface configuration. Using vlan 4 as an example. To configure static routing, add static routes to the configuration: OSPF is a dynamic routing protocol widely used in corporate networks. To configure OSPF on the Ufispace device: V4 V6 Add the interfaces participating in OSPF using the following commands: To check that the settings are correct and working: Finally, save the configuration to ensure that the changes are retained after a reboot: Conclusion Configuring static and dynamic routing on Ufispace equipment involves specific steps to define IP addresses on interfaces, add static routes and configure routing protocols such as OSPF and BGP. By following this guide, you can set up efficient and robust routing on your network. By the end of this guide, you will be ready to configure static and dynamic routing on Ufispace devices, using protocols such as OSPF and BGP to ensure an efficient and robust network. Follow the steps carefully, and if you have any questions, consult the official documentation or seek expert assistance. Would you like to speak with one of our UfiSpace and IPInfusion specialists? We at Made4it are experts in these technologies and offer comprehensive configuration and support services. In addition, we are official partners of Padtec, which sells UfiSpace routers. Contact us to learn more and optimize your network with professional solutions. See you later! https://made4it.com.br/